Deodorizer-fungicide designed for hospital and institutional use. A quaternary-based formulation, when used on environmental, inanimate, hard surfaces at 2 oz. per gallon of water is effective against Influenza A2, Herpes Simplex, Adenovirus Type 2, and Vaccinia viruses. Kills HIV-1. Add 2 oz. per gallon of water for 700ppm disinfectant application.
EPA Reg. No. 10324-120-3640
pH (concentrate) - 11.7

NSF Certified Category Code - D2

#2020 - 4 x 1 gallon case
Also available in Premeasured sizes.

Directions

It is a violation of Federal Law to use MARK 11 in a manner inconsistent with its labeling.

MARK 11 is not for use on medical device surfaces. MARK 11 is not for use to disinfect, sanitize or clean eating equipment, glassware or dishware.

DISINFECTION PREPARATION OF USE SOLUTION:
For water hardness up to 200 ppm to disinfect hard, non-porous surfaces mix a 1/2-ounce packet with 1 quart of water. Treated surfaces must remain wet for 10 minutes.

Disinfection/Fungicidal/*Virucidal Directions:
Apply use solution to hard inanimate, non-porous surfaces thoroughly wetting surfaces as recommended and required, with a cloth, mop, sponge or sprayer. For sprayer applications use a coarse spray device. Spray 6-8 inches from surface and rub with brush, sponge or cloth. Do not breathe spray.

Add 1/2 ounce per quart (16 milliliters per liter) of water to disinfect hard, non-porous surfaces. Treated surfaces must remain wet for 10 minutes. Prepare a fresh solution at least daily or when use dilution becomes diluted or soiled.

Non-Acid Toilet Bowl and Urinal Disinfection/Cleaner Directions:
Remove gross filth prior to disinfection.
From use solution: Empty toilet bowl or urinal and apply 1/2 ounce per quart (16 milliliters per liter) use solution to exposed surfaces including under the rim with a cloth, mop, sponge or sprayer, brush or swab thoroughly and allow to stand for 10 minutes and flush.

Cleaning/Deodorizing Directions:
Add 1/2 ounce per quart (16 milliliters per liter) of water to clean and deodorize windows, mirrors and non-food contact glass surfaces. When using a coarse spray device, spray 6-8 inches from surface. Rub with sponge or cloth. Do not breathe spray.

Sanitizing Non-Food Contact Surface Directions
Preparation of sanitizer use solution: Add 1/2 ounce (of Mark 11) per quart of water (or equivalent use dilution) to sanitize hard, non-porous environmental surfaces.

Apply sanitizer use solution to pre-cleaned, hard, non-porous surfaces with a cloth, mop, sponge, sprayer or by immersion.

For sprayer applications, use a coarse pump or trigger sprayer. Spray 6-8 inches from surface and rub with brush, sponge or cloth. Do not breathe spray.

Treated surfaces must remain wet for 3 minutes, then wipe with sponge, mop or cloth or allow to air dry.

This product not for use to disinfect, sanitize or clean eating utensils, glassware and dishes.