Ready-To-Use Vehicle Wash for Pressure Washers

Category: Automotive
Add to wishlist
+

Lifts the dirt, grease and grime that accumulates on your vehicle's surface. It will not harm any surface on your car's exterior. Vehicle Wash is also safe to use on plastic and vinyl.

Product Number 1001785
Old Product # ST-178
AutomotiveAutomotive Pressure Wash Solutions- Ready-to-Use

#1001785 - 4 x 1 gallon

DIRECTIONS FOR USE WITH A PRESSURE WASHER

  1. Use water without detergent in an initial cleaning to remove loose soil. Consult the pressure washer manufacturer's recommendations for maximum water temperature.
  2. Place detergent suction tube directly into container of Vehicle Wash Ready-To-Use (RTU) solution. Adjust metering valve (if applicable) to desired setting. Set nozzle to low pressure, hold the nozzle 12-18 inches from the surface. Spray soiled areas, working from the bottom up and allow Vehicle Wash RTU solution to penetrate for 1-3 minutes. If needed, use a soft brush on heavily soiled areas. 
  3. Rinse with high pressure water until foam is completely removed. Do not wash in direct sunlight or allow solution to dry on surface.

DIRECTIONS FOR HAND APPLICATION

  1. Add 5 ounces of Vehicle Wash RTU to a bucket of water and mix thoroughly.
  2. Do not apply Vehicle Wash RTU solution in direct sunlight. Seek a shaded location.
  3. Apply Vehicle Wash RTU solution to pre-cleaned surfaces with a sponge, soft brush or soft cloth.
  4. Rinse thoroughly with water and dry with a chamois or microfiber towel. 

Attachments